If your Kenmore washer model 110 is not functioning properly, taking it apart is a necessary step to diagnose and repair the issue. While it may seem daunting, with the right tools and knowledge, it can be a straightforward process. Here is a step-by-step guide on how to take apart a Kenmore washer model 110.
Before You Begin
Before you start taking apart your Kenmore washer, make sure to unplug it and turn off the water supply. It is also essential to have the proper tools on hand, including a flathead screwdriver, Phillips screwdriver, needle-nose pliers, and a socket wrench set. You may also need a putty knife to remove any adhesive components.
Step 1: Remove the Control Panel
The first step in taking apart your Kenmore washer is to remove the control panel. To do this, locate the two screws at the bottom of the panel and use your Phillips screwdriver to remove them. Then, slide the control panel forward and lift it up to detach it from the washer.
Step 2: Remove the Cabinet
Next, you will need to remove the cabinet of your Kenmore washer. To do this, locate the two metal clips that hold the cabinet to the back panel. Use your flathead screwdriver to release each clip, and then lift the cabinet off of the washer.
Step 3: Remove the Agitator
If you need to access the agitator, now is the time to remove it. To do this, remove the fabric softener dispenser from the top of the agitator and use your socket wrench to remove the bolt in the center. Then, lift the agitator out of the washer.
Step 4: Remove the Pump
If you need to access the pump, you will need to remove it next. To do this, locate the two clips that hold the pump to the motor and use your needle-nose pliers to release them. Then, disconnect the pump hoses and lift the pump out of the washer.
Step 5: Remove the Motor
Finally, you will need to remove the motor from your Kenmore washer. To do this, locate the two bolts that hold the motor to the transmission and use your socket wrench to remove them. Then, disconnect the wiring harnesses and lift the motor out of the washer.
Related Questions
How do I access the drum on my Kenmore washer model 110?
To access the drum on your Kenmore washer model 110, you will need to remove the cabinet and agitator. Once these components are removed, you can access the drum.
How do I replace the belt on my Kenmore washer model 110?
To replace the belt on your Kenmore washer model 110, you will need to remove the cabinet and the pump. Then, release the tension on the belt and slip it off of the motor and pulley. Finally, install the new belt and reassemble the components.